驱动安装过程中出现“ifconfig: command not found”报错
2025/04/28
23
问题信息
| 问题来源 | 产品大类 | 产品子类 | 关键字 |
|---|---|---|---|
| 现网 | 安装部署 | 驱动固件 | ifconfig、not found、报错 |
问题现象描述
Atlas 200I A2 加速模块环境驱动安装过程中提示“ifconfig: command not found”报错打印，如图1所示。
原因分析
系统未安装net-tools工具。
解决措施
- 执行如下命令，安装net-tools工具。
apt-get install net-tools
- 执行ifconfig命令，若出现如下回显内容，则说明net-tools可用。
endvnic: flags=4163<UP,BROADCAST,RUNNING,MULTICAST> mtu 1500 inet6 fe80::xxxx:xxxx:xxxx:fb71 prefixlen 64 scopeid 0x20<link> ether 10:1b:54:xx:xx:d3 txqueuelen 1000 (Ethernet) RX packets 0 bytes 0 (0.0 B) RX errors 0 dropped 0 overruns 0 frame 0 TX packets 0 bytes 0 (0.0 B) TX errors 29 dropped 29 overruns 0 carrier 0 collisions 0 enp0s31f6: flags=4163<UP,BROADCAST,RUNNING,MULTICAST> mtu 1500 inet 192.168.1.100 netmask 255.255.255.0 broadcast 192.168.1.255 inet6 fe80::xxxx:xxxx:xxxx:cb44 prefixlen 64 scopeid 0x20<link> ether 00:30:64:xx:xx:cb txqueuelen 1000 (Ethernet) RX packets 6056 bytes 562783 (562.7 KB) RX errors 0 dropped 990 overruns 0 frame 0 TX packets 1263 bytes 113787 (113.7 KB) TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0 device interrupt 16 memory 0xdf100000-df120000 enp10s0: flags=4099<UP,BROADCAST,MULTICAST> mtu 1500 ether 00:30:64:xx:xx:ca txqueuelen 1000 (Ethernet) RX packets 0 bytes 0 (0.0 B) RX errors 0 dropped 0 overruns 0 frame 0 TX packets 0 bytes 0 (0.0 B) TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0 device memory 0xdf000000-df01ffff lo: flags=73<UP,LOOPBACK,RUNNING> mtu 65536 inet 127.0.0.1 netmask 255.0.0.0 inet6 ::1 prefixlen 128 scopeid 0x10<host> loop txqueuelen 1000 (Local Loopback) RX packets 3853 bytes 234436 (234.4 KB) RX errors 0 dropped 0 overruns 0 frame 0 TX packets 3853 bytes 234436 (234.4 KB) TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0