Operator Prototype Is Not Registered

Symptom

An error is reported in the log, indicating that an operator does not have a prototype definition:

op[%s] type[%s] have no ir factory.

Or

IR for op[%s] optype[%s] is not registered.

Possible Cause

• The operator prototype .so file fails to be loaded.
• The operator type is not registered or compiled into the operator prototype .so file.

Solution

1. Check whether the operator prototype .so file is successfully loaded.
   • Information displayed if the operator prototype .so file is successfully loaded:

     OpsProtoManager plugin load ******/opp/built-in/op_proto/libopsproto.so success.

   • Key warning information in the case of loading failure:

     OpsProtoManager dlopen failed, plugin name:%s. Message(%s).

2. If the operator prototype .so file is successfully loaded, check whether the operator prototype definition is compiled into the loaded .so file.

   Run the nm command to view the SO symbol table. If the operator prototype is not registered, register it. For details, see the Operator Prototype Definition section in TBE & AI CPU Operator Development.

   

   You can run the nm -D command to view the symbol table of the .so file.

3. If the operator prototype .so file fails to be loaded, rectify the fault by referring to the message in the failure warning.